The Welkin Suite Forum

[Solved] Deployment to a Sandbox (by pass validation)



Deployment to a Sandbox (by pass validation)

  • Please log in to reply

#1

repsg

    Posted 22 Nov 2015 and edited 20 Jan 2018

    Hi,


    I started using this software yesterday and I do very much like the editor. I will be recommending it at Work.


    I was deploying to our full sandbox and noticed that Welkin Suite said that the deployment was a successful. When I logged into the sandbox, the components were not deployed because it failed the running test.


    So I would like to see the following features.


    1. When deploying to an org, when selecting the components to deploy it would be good to show the custom folder structure.


    2. When Deploying to an org, instead of a success message, a message to the effect of 'Deployment is being tested please see deployment status within the org'


    3. Ability to deploy to sandbox by-passing the running of testmethods. When completed the message to say success. If failed, then it should say failed and bring back the results of the failure.


    Thanks  





    1 replies to this topic

    #2

    kate.dulko

      Posted 23 Nov 2015

      Hi,
       

      Thank you for your feedback about the IDE and your suggestions. All of them are efficient.

      Our team should discuss some ways for the implementation of them and in the next several days I’ll write some details, comments, and (probably) time estimates for this.


      Regards,

      Kate


      Kate Dulko
      Customer Relations

      The Welkin Suite

      twitter: @KateDulko
      skype id: d_katerina
      e-mail: kate.dulko@welkinsuite.com

       

        


      Boost Your Productivity. Get Started Today

      Try Free Trial